Hi all,
I have a need to configure a very large queue that is able to store about 1 million messages of around 10kb each. The queue will be too big to fit into RAM, and will need to spool to disk.
I have been struggling to configure the queue, as the queue seems to become full after a few thousand messages. Is there a definitive set of command line options to qpid-config that will create a queue bigger than RAM but that will fit on disk?
The errors we have received are related to qpid complaining that failover has failed - which is strange as there is just a single broker with no alternative brokers to fail over to. Does this ring a bell?
Regards,
Graham
—
I have a need to configure a very large queue that is able to store about 1 million messages of around 10kb each. The queue will be too big to fit into RAM, and will need to spool to disk.
I have been struggling to configure the queue, as the queue seems to become full after a few thousand messages. Is there a definitive set of command line options to qpid-config that will create a queue bigger than RAM but that will fit on disk?
The errors we have received are related to qpid complaining that failover has failed - which is strange as there is just a single broker with no alternative brokers to fail over to. Does this ring a bell?
Regards,
Graham
—